Furniture Mismatch Assessment and Human Factor Issues in Primary Healthcare Facilities of Calabar Metropolis, Nigeria
Published 22-08-2026
Keywords
- Anthropometry,
- Ergonomics Mismatch,
- Healthcare Workers Furniture,
- Primary Facilities,
- Musculoskeletal disorders
How to Cite
Copyright (c) 2026 Asibong Asibong Icha, Nureni Adedapo Adewole

This work is licensed under a Creative Commons Attribution 4.0 International License.
Dimensions
Abstract
Introduction: Furniture-user mismatch is a recognised occupational health risk, yet no study has systematically evaluated ergonomic compatibility between healthcare workers (HCWs) and furniture in Nigerian primary healthcare facilities (PHCFs). This study assessed the anthropometric profile of HCWs in public PHCFs in Calabar Metropolis, Cross River State, Nigeria, and evaluated the degree of mismatch between their body dimensions and their workstations. Methods: A total of 145 HCWs (47 males, 98 females) were recruited across 25 selected PHCFs. Thirteen anthropometric parameters were measured in accordance with ISO 7250. Six chair types (four armchairs and two armless chairs) and fifteen table types were dimensionally assessed. Match and mismatch percentages were computed by comparing furniture dimensions against ergonomically derived acceptable ranges based on the 5th and 95th percentile values of relevant anthropometric parameters. Results: Study revealed pervasive mismatch across all furniture types and dimensions. Among armchairs, seat height match rates did not exceed 33.3% in any group, while armrest height match was below 15% across all four types. Armless chairs performed comparatively better, with Chair Type 3 achieving up to 66.7% seat height match in males. Table height mismatch exceeded 70% for nearly all fifteen table types, with upper mismatch being the dominant pattern. Conclusion: Findings of the present study demonstrate a critical ergonomic deficit in primary healthcare furniture in Calabar Metropolis and underscore the urgent need for anthropometrically informed furniture design and procurement policies to protect HCWs from musculoskeletal disorder (MSDs) risk.
References
- Adiga, U. (2023). Enhancing occupational health and ergonomics for optimal workplace well-being: a review. International Journal of Chemical and Biochemical Sciences, 24(4): 157-164.
- Aiyegbusi, A.I., Gbiri, C.A., Oyeniran, T.O., and Balogun, O.J. (2023). Mismatch between school furniture dimensions and anthropometric parameters is a risk for spinal deformities in secondary school students in Lagos, Nigeria: a cross-sectional study. Bulletin of Faculty of Physical Therapy, 28(34): 1-8. https://doi.org/10.1186/s43161-023-00145-8
- Altaboli, A., Muttardi, R., Alahmar, H., Aliskandarani, H., Alshaikhi, A., (2023). Anthropometric evaluation of university classroom furniture. Physical Ergonomics and Human Factors 103: 1–10. https://doi.org/10.54941/ahfe1003040
- Bitton, A., Ratcliffe, H.L., Veillard, J.H., Kress, D.H., Barkley, S., Kimball, M., Secci, F., Wong, E., Basu, L., Taylor, C., Bayona, J., Wang, H., Lagomarsino, G., Hirschhorn L.R. (2017). Primary health care as a foundation for strengthening health systems in low-and middle-income countries. Journal of general internal medicine, 32(5): 566-571. https://doi.org/10.1007/s11606-016-3898-5
- Bolarinwa, M.A., Kumapayi, A.O., (2023). Ergonomic risk assessment of Nigerian teaching personnel: Cases of a secondary school and a tertiary institution in Ibadan, Nigeria. European Journal of Medical and Health Sciences, 5(4): 56–62. https://doi.org/10.24018/ejmed.2023.5.4.1865
- Del Prado-Lu, J.L. (2007). Anthropometric measurement of Filipino manufacturing workers. International Journal of Industrial Ergonomics, 37(6): 497–503. https://doi.org/10.1016/j.ergon.2007.02.004
- Fidelis, O.P., Ogunlade, B., Adelakun, S.A., Adukwu, O. (2018). Ergonomic analysis of classroom furniture in a Nigerian university. Nigerian Journal of Technology, 37(4): 1154–1161. https://doi.org/10.4314/njt.v37i4.40
- Garosi, E., Sheikh, F., Goodarzi, M., (2025). Ergonomic interventions in risk reduction. In: Ergonomics and Workplace Safety. IntechOpen. https://doi.org/10.5772/intechopen.1008463
- Haque, M., Islam, T., Rahman, N.A.A., McKimm, J., Abdullah, A., Dhingra, S. (2020). Strengthening primary health-care services to help prevent and control long-term (chronic) non-communicable diseases in low-and middle-income countries. Risk management and healthcare policy, 409-426. https://doi.org/10.2147/RMHP.S239074
- Ibrahim, Z.A., Konlan, K.D., Moonsoo, Y., Kwetishe, P., Ryu, J., Ro, D.S., Kim, S.Y. (2023). Influence of basic health care provision fund in improving primary health care in Kano State: A descriptive cross-sectional study. BMC Health Services Research 23: 885. https://doi.org/10.1186/s12913-023-09708-w
- Icha, A.A, Adewole, N.A., (2026). Dimensional analysis and characteristics of chairs and tables utilized by public healthcare workers in Calabar metropolis, Nigeria, Furniture and Wooden Material Research Journal, 9(1): 63-75. https://doi.org/10.33725/mamad.1864597
- International Organization for Standardization (ISO). 2017. ISO 7250-1:2017: Basic human body measurements for technological design—Part 1: Body measurement definitions and landmarks. Geneva, Switzerland.
- Isapka, A.I., Omorodion, O.A., (2019). The Mismatch of Students Anthropometric Data with Ergonomic Designs of Learning Workstation is a Risk Factor for Musculoskeletal Disorders. International Journal of Sciences, 8(02): 105–111. http://dx.doi.org/10.18483/ijSci.1913
- Ismaila, S.O., Musa, A.I., Adejuyigbe, S.B., Akinyemi, O.D., (2013). Anthropometric design of furniture for use in tertiary institutions in Abeokuta, South-western Nigeria. Engineering Review, 33(3): 179–192.
- Kamijantono, H., Sebayang, M.M., Lesmana, A., (2024). Risk factors and ergonomic influence on musculoskeletal disorders in the work environment. Journal La Medihealtico, 5(3): 660–670.
- Kruk, M.E., Porignon, D., Rockers, P.C., Van Lerberghe, W. (2010). The contribution of primary care to health and health systems in low- and middle-income countries: A critical review of major primary care initiatives. Social Science & Medicine, 70(6): 904-911. https://doi.org/10.1016/j.socscimed.2009.11.025
- Lee, Y. (2019). Anthropometric design and ergonomic posture assessment based on intelligent algorithms for seated work. S-Space.
- Malone, E. B., & Dellinger, B. A. (2011). Furniture design features and healthcare outcomes. The Center for Health Design, 1-72.
- Obaseki, C., Erhabor, N.I., (2023). Ergonomic standard compliance of nurses in tertiary hospitals in Edo State, Nigeria. NIU Journal of Social Sciences 9(4): 199–205. https://doi.org/10.58709/niujss.v9i4.1778
- Oche, M. Adamu, H. (2013). Determinants of Patient Waiting Time in the General Outpatient Department of a Tertiary Health Institution in North Western Nigeria. Annals of Medical and Health Sciences Research, 3(4): 588. https://doi.org/10.4103/2141-9248.122123
- Odebiyi, D.O., Okafor, U.A.C., (2023). Musculoskeletal disorders, workplace ergonomics and injury prevention. Ergonomics – New Insights. https://doi.org/10.5772/intechopen.106031
- Oladapo, S.O., Olusola, E.O., Akintunlaji, O.A., (2024). Anthropometric comparison between classroom furniture dimensions and female students’ body measurements for enhanced health and productivity. International Journal of Research and Innovation in Applied Science IX. https://doi.org/10.51584/IJRIAS.2024.905030
- Olumide, B.O., Tyem, N.F., Ntuhun, B.D., Ekpenyong, M.E., Ariyo, S.T., Selowo, T.T., Fiyaktu, Y.B., (2024). Evaluation of ergonomics awareness and its lack of application among medical laboratory practitioners in tertiary hospitals in Jos, Nigeria. International Journal of Medicine and Health Development, 29(2): 103–113.
- Paula, C.C.D., Silva, C.B.D., Tassinari, T.T., Padoin, S.M.D.M. (2016). Factors that affect first contact access in the primary health care: integrative review. Revista de Pesquisa: Cuidado é Fundamental Online, 8(1): 4056-4078. https://doi.org/10.9789/2175-5361.2016.v8i1.4056-4078
- Perumal, M. (2023). The effects of exposure to ergonomic hazards among medical laboratory technicians at a Government Hospital in KwaZulu-Natal. University of Johannesburg.
- Saha, A.K., Jahin, M.A., Rafiquzzaman, M., Mridha, M.F. (2024). Ergonomic design of computer laboratory furniture: Mismatch analysis utilizing anthropometric data of university students. Heliyon, 10(14). https://doi.org/10.1016/j.heliyon.2024.e34063
- Sejdiu, R., Sylejmani, B., Idrizi, L., Bajraktari, A., & Sejdiu, M. (2023). Discrepancy between pupils’ body and classroom furniture in elementary schools: A case study in the Republic of Kosovo. Work, 75(2): 447-459. https://doi.org/10.3233/WOR-220023
- Smardzewski, J. (2015). Furniture design. Berlin/Heidelberg, Germany: Springer. https://doi.org/10.1007/978-3-319-19533-9
- Taifa, I.W., Desai, D.A. (2017). Anthropometric measurements for ergonomic design of students’ furniture in India. Engineering Science and Technology, an International Journal, 20(1), 232-239. https://doi.org/10.1016/j.jestch.2016.08.004
- World Health Organization. (2017). Primary health care systems (Primasys). World Health Organization.
- Yisa, S.S., Ogunniyi, T.J., Dine, R.D. (2025). Strengthening primary health care in Nigeria: A means to achieve universal health coverage. BMJ Global Health, 10(10): e018486. https://doi.org/10.1136/bmjgh-2024-018486
